Command line switches to control Ghost or Console?
-
- Posts: 2
- Joined: Wed Mar 08, 2006 10:28 pm
-
- Posts: 2
- Joined: Wed Mar 08, 2006 10:28 pm
-
- Site Admin
- Posts: 307
- Joined: Fri Feb 13, 2004 5:55 pm
Hi. I had the same question as the original poster. Is there a way to control the "silent" mode flag if I am doing the compile from the command line?
I know right now the command line seems to use the last setting that was made when the tool is used in interactive mode. However, we need to do many compiles.. some are silent, some are not.. It is a pain to have to go into interactive mode just to switch the "silent" mode on and off.
Basically, what I want to do is:
quickbfc.exe /silent xxx yyy
Is this possible?
Thanks,
John
I know right now the command line seems to use the last setting that was made when the tool is used in interactive mode. However, we need to do many compiles.. some are silent, some are not.. It is a pain to have to go into interactive mode just to switch the "silent" mode on and off.
Basically, what I want to do is:
quickbfc.exe /silent xxx yyy
Is this possible?
Thanks,
John
-
- Site Admin
- Posts: 307
- Joined: Fri Feb 13, 2004 5:55 pm
-
- Site Admin
- Posts: 307
- Joined: Fri Feb 13, 2004 5:55 pm
-
- Site Admin
- Posts: 307
- Joined: Fri Feb 13, 2004 5:55 pm
I think you have older version 2.0.7.1
Please update it to version 2.0.8.5 from https://www.abyssmedia.com/downloads/qbfc-beta.exe
Please update it to version 2.0.8.5 from https://www.abyssmedia.com/downloads/qbfc-beta.exe