Hello,
I've got my batch running ok with .bat but when it is complied with qbfc it is not running I've got this message "Cannot load VDM IPX/SPX support ".
I've seen this only on one system but on then other system it is ok, all system are running on XP.
Anybody can help?
Thanks.
Cannot load VDM IPX/SPX support - when exe ran
-
- Posts: 3
- Joined: Tue Oct 20, 2009 9:41 am
-
- Site Admin
- Posts: 476
- Joined: Fri Feb 13, 2004 1:05 pm
Symptom: When you open a DOS shell or if you run some programs in the DOS shell, you will get an error: Cannot load VDM IPX/SPX support
Causes: On Windows 2000 (maybe Windows XP and others), when you install CSNW and Novell's Netware client, it adds extra stuff to your autoexec.nt file. When you uninstall the client, it leaves a few turds around on your system (don't they all?) that could cause problems.
Solution: Edit your %SystemRoot%\system32\autoexec.nt file and look for these lines:
REM Install network redirector
lh %SystemRoot%\system32\nw16
lh %SystemRoot%\system32\vwipxspx
When you find them, just REM the lines out or delete them entirely.
Problem solved.
Causes: On Windows 2000 (maybe Windows XP and others), when you install CSNW and Novell's Netware client, it adds extra stuff to your autoexec.nt file. When you uninstall the client, it leaves a few turds around on your system (don't they all?) that could cause problems.
Solution: Edit your %SystemRoot%\system32\autoexec.nt file and look for these lines:
REM Install network redirector
lh %SystemRoot%\system32\nw16
lh %SystemRoot%\system32\vwipxspx
When you find them, just REM the lines out or delete them entirely.
Problem solved.
-
- Posts: 3
- Joined: Tue Oct 20, 2009 9:41 am
-
- Site Admin
- Posts: 476
- Joined: Fri Feb 13, 2004 1:05 pm
-
- Posts: 3
- Joined: Tue Oct 20, 2009 9:41 am