Here is what i am trying to do ... compile a bat file into exe which runs in 'invisible' mode.
However if on some systems this batch file does not seem to run or terminate abruptly i would need to see at what point does the code crash, hence is there a way within the batch code to make this application back to visible mode ?
Eg: If i run my program as "myprogram.exe -debug" then i can set the batch file to check if the parameter 'debug' was entered and switch over to 'visible' mode so that i can see the execution of the batch commands.
Ghost Application Change to Visible mode
-
- Posts: 2
- Joined: Wed Jul 03, 2013 1:24 am
- Location: India